Oxylight Directions

Getting started

1. Thoroughly wash and pat your skin dry before starting.
2. Turn the dial to the lowest setting.
3. Plug the Oxylight into an electrical outlet. The unit will immediately begin to generate a high-frequency pulse. Give it a few seconds to warm up. Some units can take up to a minute to warm up when they are first turned on or after sitting for a couple of days. Please be patient.
4. Touch the bulb to your hand. You will feel a slight tingling sensation and the bulb will glow with an orange light.
5. If you touch the bulb to an inanimate object, like the table, the bulb will not glow. This is because it requires the energy from your body to activate it.
6. Lift the bulb slightly off of your skin, about an eighth of an inch, so that a stream of high-frequency energy passes between the bulb and your hand. You will be able to smell the enriched oxygen being produced.
7. With the unit still set at the lowest level, place the bulb directly on the area to be treated. Work at the lowest intensity until you feel comfortable with the sensation of the Oxylight.
8. By turning the dial, gradually increase the intensity until you reach a level that is comfortable.

Note that you may experience different comfort levels in different areas of your face. Always work at the highest level that you are comfortable with for the best results. You cannot hurt yourself, even at the highest level.

Cleansing and purifying

1. Sweep the bulb of your Oxylight back and forth over your face and neck. You may prefer to work in a circular motion. Use whatever motion is most comfortable for you. The important thing is to sweep your entire face and neck.

Applying creams and lotions

1. Using your Oxylight, cleanse and purify your skin.
2. Continue with your usual skincare regime. If you use toner, apply it now. Then apply your favorite creams and lotions.
3. Lightly sweep your Oxylight over your entire face to enhance the effectiveness of your skincare products.

Firming and toning

By gently stimulating your facial muscles, the Oxylight firms and tones your skin.

Using your Oxylight, thoroughly cleanse and purify your skin.

1. Apply your favorite creams and lotions.
2. Start with your forehead. Touch the bulb of your Oxylight to your skin just above your eyebrows and sweep up towards your hairline. Do not lift the bulb from the surface of your skin while you are sweeping. When you reach your hairline, lift the bulb. Repeat until you have swept your entire forehead.
3. Next, move to your eyes. Turn your Oxylight to its lowest setting. Circle your eye with your Oxylight in a continuous motion. Start at your temple, sweep underneath your eye along your cheekbone to the bridge of your nose, then below your eyebrow back to your temple. Circle each eye 5 times without lifting the bulb from your skin.
4. Now firm and tone your cheeks. Adjust your Oxylight to a level you are comfortable with. Beginning at your jawline, sweep your Oxylight upwards. When you reach the top of your cheekbone, lift your Oxylight. Repeat until you have covered both your cheeks. Remember, always sweep in an upwards direction to achieve maximum lift.
5. Finally, move to your neck. Starting at your collarbone, sweep your Oxylight up over your jawline, then lift it from your skin. Repeat until you have covered your entire neck.

Firming and toning problem areas

Once you have firmed and toned your face, you can focus on your problem areas using the methods outlined below, or do them all to give your whole face a lift. To achieve the most dramatic results, use firmer pressure on the upward strokes and lighter pressure on the downward strokes.

Neck and Jawline

1. Place the bulb of your Oxylight just under the middle of your chin. Using moderate pressure, glide the bulb along your jawline to just below your ear lobe. Hold for a count of 5. Repeat three times on each side.
2. Next, place the bulb just under the middle of your chin and glide, with moderate pressure, up to the corner of your lower lip. Hold for a count of 5. Repeat three times on each side.
3. Once again, place the bulb just under the middle of your chin and glide with moderate pressure along your "laugh lines" up to the side of your nose. Repeat this movement three times on each side, holding for a count of 5.
4. Place the bulb of your Oxylight just under your chin again. Lift the skin up over your jawbone and hold for a count of 5. Do this three times, then repeat the movement in a different place until you have lifted your entire jawline.

Cheeks

1. Place the bulb of your Oxylight at the side of your nose and, with moderate pressure, glide along the cheek bone to your temple. Hold for a count of 5. Repeat three times on each side.

Eyes

The following steps will help to firm and lift your eye area. For the first few days, turn your Oxylight down to the lowest setting. Then gradually increase the setting, working at the highest level you find comfortable. Remember, higher levels produce better results.

1. Place the bulb of your Oxylight underneath the inside corner of your eyebrow. Press gently and lift the skin towards your brow. Do not slide the bulb as you do in other treatments. Hold while counting to 5. Release. Repeat until you have lifted your entire brow.
2. Next, place the bulb of your Oxylight just above your eyebrows and sweep up towards your hairline. When you reach your hairline, hold for a count of 5. Repeat until you have lifted your entire forehead.

Puffy eyes

The stippling action of the Oxylight helps to drain the lymphatic system below the eyes, dramatically reducing puffiness.

1. Apply eye cream or moisturizer to your eye area to ease gliding.
2. Turn your Oxylight to its lowest setting.
3. Place the bulb on your cheekbone just below the inside corner of your eye. Sweep along your cheekbone underneath your eye to your temple. Hold for a count of 3, then continue the sweep down to your jawline. Repeat 5 times on each eye.

You may not see immediate results, but within 5 minutes you will begin to notice significant diminishing of the puffiness under each eye..

Usage precautions

High frequency technology has been around for years and has proven safe and effective. If you have any of the following conditions, however, you should not use the Oxylight.

Rosacea

Do not use the Oxylight if you are prone to Rosacea. If you suspect you have this condition, consult your dermatologist. Rosacea can be aggravated by any type of massage and the Oxylight provides a stimulating massage.

Excessive capillaries

If you have excessive capillaries or blood vessels near the surface of your skin, you should not use the Oxylight. A few visible capillaries are not a problem, but if you have a large number of them, using any type of massaging apparatus will exacerbate the problem.

Acid peels

Do not use the Oxylight with products that chemically peel your skin. Acid peels actually remove a layer of skin, bringing your delicate capillaries closer to the surface. While undergoing these treatments, any type of massage can over stimulate your already stressed skin. We recommend that you postpone use of your Oxylight until your skin has had time to recover.

Pacemaker

The Oxylight produces an electrical signal that could interfere with the electrical functioning of a pacemaker. We have never had an incident involving a pacemaker, but common sense suggests that if you have a pacemaker, you should not use the Oxylight.

A note on pregnancy

During pregnancy, you may experience changes in your complexion. Some women develop acne. Others notice skin discoloration. These are a natural result of hormonal changes. Rather than treat them, we recommend that you postpone use of your Oxylight until your skin returns to normal.

For external use only

The Oxylight is for external use only. Do not use on mucous membranes (eyes, mouth, nose, etc.) The Oxylight is not to be used internally.

Possible problems

Excessive peeling

If you are experiencing excessive peeling, you are using your Oxylight at too high a setting and/or for too long a period of time. Stop using your Oxylight until your skin regains its normal texture and color. When you start using it again, lower the setting and reduce the duration of each session.

Excessive redness or swelling

Because it increases blood flow, any massage will cause redness to occur. This is normal. If you experience excessive redness or swelling, you may be over stimulating your skin. Stop using your Oxylight until your skin regains its normal texture and color. When you start using it again, lower the setting and reduce the duration of each session.

Handling and storage

The bulb of your Oxylight is breakable. Store your Oxylight in its case when not in use and never operate a unit with a broken bulb. Return it to the manufacturer for repair.

Electrical precautions

As with any electrical appliance, you should observe the following precautions.

• Do not use outdoors.
• Do not immerse in water.
• Do not use while standing in, sitting in, or in contact with water.
• Do not use near flammable or combustible substances.
• Unplug the unit when not in use.
• There are no user serviceable parts inside this unit. Do not attempt to open the case.

Try the Oxylight Risk Free for 30 Days!

The Oxylight  On Sale Now PLUS Get Free Shipping

"I have only had this product for a little over a week and already notice changes. My husband thinks my face looks great and it has definitely helped with my acne. My skin feels fresh and rejuvenated. My mom and two sisters have also purchased this amazing tool. I love it !!!!" - Wendy, Columbus, OH